|
Le refuge ^_^ Le refuge des forumeurs perdus |
|
|
|
|
|
|
|
|
Toutes les heures sont au format GMT + 1 Heure
|
|
|
Mar Sep 19, 2017 7:28 |
|
Auteur |
Message |
RyanCaleb Surfeur
Inscrit le: 06 Sep 2017 Messages: 76
|
Sujet du message: Cutting The Steel Tubing |
|
|
We measured each piece of slate and were very careful not to screw up the tubing dimensions. We took the 1.5″ square tubing to our Skill Saw dry cutting saw station. We set the saw to 45* angle and made our first cut. We then measured taking into count the slate measurement we grabbed earlier. This measurement is to the inside of the 45 miter. Once we made the second cut on the first piece, we set a stop block to make sure the opposing side was exactly the same. After all, any square piece needs to have parts that have opposing sides that are the same length or you will never have a square piece.
I didn't find the right solution from the Internet.
References https://www.workshopaddict.com/tools/cedar-and-steel-chalk-board-frames-build-video/
Video marketing |
|
|
|
|
|
|
Vous ne pouvez pas poster de nouveaux sujets dans ce forum Vous ne pouvez pas répondre aux sujets dans ce forum Vous ne pouvez pas éditer vos messages dans ce forum Vous ne pouvez pas supprimer vos messages dans ce forum Vous ne pouvez pas voter dans les sondages de ce forum Vous pouvez joindre des fichiers dans ce forum Vous pouvez télécharger des fichiers dans ce forum
|
|
|
|